Installing iPhone 4 Volume Button dp-gate.com

dp-gate.com

Reviews

i like it

b,r van den brink

I LOVE THIS TEDDYBEAR

Annatje

This cover is much cheaper and maximum protection

Ashley Miller

I really like the case because I think it's Fabulus and sparkly and great

Jacqueline hooper

More Customer Testimonials

Knowledgebase

Search your questions?

Installing iPhone 4 Volume Button

Installing iPhone 4 Volume Button

Step 1 — Rear Panel

Before disassembling your iPhone, be sure it is powered off.

Remove the two 3.6 mm Phillips screws next to the dock connector.

Apple has recently substituted the two Phillips screws with 5-Point "Pentalobe" screws. If your iPhone 4 has 5-Point "Pentalobe" screws instead of Phillips, please refer to the second picture.

Remove the two 3.6 mm Pentalobe screws next to the dock connector.

During reassembly, we recommend you replace the 5-point screws with equivalent Phillips screws. Our Liberation Kit provides the tools and screws needed to replace the Pentalobe screws with Phillips screws.

The 5-Point Screwdriver should only be used once, as it has the potential to strip the screws.

Step 2

Push the rear panel toward the top edge of the iPhone.

The panel will move about 2 mm.

Step 3

Remove the rear panel from the iPhone.

Step 4 — Battery

Remove the single 2.5 mm Phillips screw securing the battery connector to the logic board.

Step 5

Use an iPod opening tool to carefully pry the battery connector up from the ends closest to the top and bottom edges of the iPhone.

Do not pry against the pressure contact.

Remove the pressure contact from the iPhone.

Step 6

Use the clear plastic pull tab to gently lift the battery out of the iPhone.

Be careful when removing the battery with the plastic pull tab. On some units, Apple uses an excessive amount of glue, making it virtually impossible to remove the battery in this fashion (with the tab possibly tearing due to excessive force).

For batteries that "stick", you could use the iPod opening tool to assist (take extra care whilst doing so).

Remove the battery.

Before reconnecting the battery connector, be sure the pressure contact (shown in red) is properly positioned next to the battery connector.

Before reassembly, be sure to clean all metal-to-metal contact points on the pressure contact as well as its contact point on the rear panel with a de-greaser such as windex. The oils on your fingers have the potential to cause wireless interference issues.

Step 7 — Volume Button

Use a pair of tweezers to remove the small strip of tape covering the back of the volume buttons.

Be sure to peel the tape starting from nearest the top of the phone.