Installing iPhone 4S Rear Panel dp-gate.com

Installing iPhone 4S Rear Panel

Installing iPhone 4S Rear Panel Replace a cracked rear panel on your iPhone 4S. Difficulty: Easy
Sections: Rear Panel 3 steps	Tools: iPhone 4 5-Point Pentalobe Screwdriver
Step 1 — Rear Panel Before disassembling your iPhone, be sure it is powered off. Remove the two 3.6 mm Pentalobe screws next to the dock connector. During reassembly, we recommend you replace the 5-point screws with equivalent Phillips screws. Our Liberation Kit provides the tools and screws needed to replace the Pentalobe screws with Phillips screws. The 5-Point Screwdriver should only be used once, as it has the potential to strip the screws.
Step 2 Push the rear panel toward the top edge of the iPhone. The panel will move about 2 mm.
Step 3 Pull the rear panel away from the back of the iPhone, being careful not to damage the plastic clips attached to the rear panel. Remove the rear panel from the iPhone.

This page was: Helpful | Not Helpful